Billsta, I wouldnt' be suprised if the boot was very similar.
I climbed under and took a fairly rough measure and presented it to the Repco staff who promptly said "Generic Boot".
The boot is tight on the axle and needs some vaseline to skid up to the CV joint. The bearing housing is a firm fit as well.
I have forgotten the measurements so I will go and do them now and get back soonest. If the measure is close then I'm sure the boot will fit.
Next message....... [img]graemlins/sleep.gif[/img]
jess ross, no need to rush, can have the measurment bit later, i can always go and measure mine as well, so we can do a compero here for future reference..
last time i checked with DC they wanted to charge me an arm and a leg for them,. but i think i really need them this time around...
Don't delay in doing them. Made the same mistake with Chris's Mazda a while back and leaving the boot open alowed dirt and crud to destroy the CV joint. Then they became big dollars to replace the entire axle and CV joint. [img]graemlins/crazy.gif[/img]
thanks for that ross,
i'll have a look tomorrow,
my boots are still there, but its spitting out the grease, am getting a service soon, so it might be done then as well..
Comment