I purchased a new ignition barrel for my WJ 2002 as the key keeps falling out. I have to take it in for a roadworthy and know it will get knocked for it. The barrel finally arrived and I installed it today, but it wouldnt let me turn the key to get the starter to turn the engine over. Both barrels look identical bar one thing. On the end of the key barrel tang there is a small hole. The original jeep barrel has what looks like a piece of plastic inserted in it, however the new barrel does not. The only thing I can think of is the plastic piece in the hole is restricting how far the matching piece that is inserted into it can go. Has anyone else had this issue? The key barrel does turn all the way to where it should start the car when out, but when in it cannot turn. Thanks in advance.
Replacement Ignition Barrel will not Start WJ
Collapse
X
-
are you using a different key as well? try putting the old key on the keyring with the
new one, they have a security code embedded in the key, if this is the problem
there may be a light on the dash, key with a line through it, on the right side I think
Cheers
Comment
-
-
I pulled the original barrell out today and replaced it with the new one. Had the old key on the keyring with the new one. The truck started up and stayed running, for a while. Turned it off and went to turn it back on, and it started up fine. Third time it ran and stopped. Old key was still on the ring but it wouldnt start. Pulled the new barrell and put the old one back in, and away it ran without issue. Think I will be taking the new barrell to be keyed for my old keys and see if that does the trick.
Comment
-
Comment